MPPT Solar Charge Controller

MPPT75-05,10 100-15 Catalogue

MPPT75-05,10 100-15 Catalogue

fangpusun solar charge controller MPPT 75/05,MPPT75/10,MPPT100/15 - Untra-fast Maximum Power Point Tracking (MPPT) Especially in case of a clouded sky, when light intensity is changing continuously, an ultra fast MPPTcontroller will improve energy harvest by up to 30% compared to PWM charge...

Product Details

fangpusun solar charge controller MPPT 75/05,MPPT75/10,MPPT100/15

Untra-fast Maximum Power Point Tracking (MPPT) 

Especially in case of a clouded sky, when light intensity is changing continuously, an ultra fast MPPTcontroller will improve energy harvest by up to 30% compared to PWM charge controllers and by upto 10% compared to slower MPPT controllers. 

Load output 

Over-discharge of the battery can be prevented by connecting all loads to the load output. The load outputwill disconnect the load when the battery has been discharged to a pre-set voltage. 

Alternatively, an intelligent battery management algorithm can be chosen: see Battery Life. The load output is short circuit proof.

Some loads (especially inverters) can best be connected directly to the battery, and the inverter remotecontrol connected to the load output. A special interface cable may be needed, please see the manual.

Battery Life: intelligent battery management

When a solar charge controller is not able to recharge the battery to its full capacity within one day, the result is often that the battery will continually be cycled between a ‘partially charged’ state and the ‘end of discharge’ state. This mode of operation (no regular full recharge) will destroy a lead-acid battery within weeks or months.

The Battery Life algorithm will monitor the state of charge of the battery and, if needed, day by day slightlyincrease the load disconnect level (i.e. disconnect the load earlier) until the harvested solar energy issufficient to recharge the battery to nearly the full 100%. From that point onwards the load disconnect level will be modulated so that a nearly 100% recharge is achieved about once every week.

Fangpusun charge controller

  MPPT75/05

MPPT75/10

MPPT 100/15

System voltage

375 Wp

12/24 V Auto Select

 

Maximum output current

      5A

10A

15A

Maximum PV power, 12V

1a,b)

70 W

        135W

200W

Maximum PV power, 24V

1a,b)

135 W

230 V

  270W

400W

Maximum PV open circuit voltage

1.5 A

         75 V

100 V

Maximum efficiency

300 W

         98 %

Self-consumption

           10 mA 

Charge voltage 'absorption'

300 W

Default setting:14,4 V / 28.8 V (adjustable)

 

Charge voltage 'float'

 

50 Hz

Default setting:13,8 V / 27,6 V(adjustable)

Charge algorithm

 

multi-stage adaptive

Temperature compensation

-16 mV / °C resp.-32 mV / °C

Continuous/peak load current

               15A/50A

Low voltage load disconnect

11,1V / 22,2V or 11,8V / 23,6V or Battery Life algorithm

Low voltage load reconnect

13,1V / 26,2V or 14V / 28V or Battery Life algorithm

Protection

Battery reverse polarity (fuse)/Output short circuit / Over temperature

< 6 % (max. power) 

Operating temperature

30 to +60°C (full rated output up to 40°C)

Humidity 

             95%,non-condensing

Data communication port

               VE.Direct

94.8 %

See the data communication white paper on our website

                                  ENCLOSURE

Colour

Terminals(fine / single wire)

 

99 %

Blue (RAL 5012)

 

6mm² / AWG10

Protection category

 

from 40 ℃

 

IIP22 (connection area)

Weight

 

  0.35 kg 0 W

0.5kg

Dimensions (X x Y x Z)

          100 x 113 x 38.5 mm

101 x 114 x 47 mm

                                   STANDARDS

Safety

voltage (230 V +15 %/-10 %)

 EN/IEC 62109

frequency (50 Hz +0.5 Hz/-3 Hz)

1a) If more PV power is connected, the controller will limit input power to the stated maximum.

resp . 500 ES

voltage (230 V +10 %/-15 %)

1b) PV voltage must exceed Vbat + 5V for the controller to start. Thereafter minimum PV voltage is Vbat + 1V

Maximum Power Point Tracking 

Upper curve: 

Output current (I) of a solar panel as function of output voltage (V).

The maximum power point (MPP) is the point Pmax along the curve where the product I x V reaches its peak. 

Lower curve: 

Output power P = I x V as function of output voltage. 

When using a PWM (not MPPT) controller the output voltage of the solar panel will be nearly equal to the voltage of the battery, and will be lower than Vmp.

Programmable battery charge algorithm 

See the software section on our website for details 

Day/night timing and light dimming option 

See the software section on our website for details 

Programming, real-time data and history display options 

- Modern Apple and Android smartphones, tablets, macbooks and other devices: see the VE.Direct Bluetooth Smart dongle and the MPPT app discovery sheet for screenshots.

- ColorControl panel

Certificates

Compliant with European Standards (CE) 

RoHS compliant 

SGS 

ISO 9001 

Made in China

Xihe Electric is one of the leading China MPPT Solar Charge Controller manufacturers, our factory is able to produce cheap mppt75-05,10 100-15 catalogue MPPT Solar Charge Controller with reliable quality. Welcome to wholesale products from us.

Hot Tags: mppt75-05,10 100-15 catalogue MPPT Solar Charge Controller, China, manufacturers, factory, wholesale, cheap
Contact Now

Our Service

Wenzhou Xihe Electric Co.,ltd ( The former: Beijing FANGPU SUNNYCO.LTD) is specialized in development, product, sales and services of Solar Controller, inverter system, etc in a body of professional company.

Feedback

Tel: 86-577-61783177

Contact Us

Address: NO.308 Latitude of 16 Road,Yueqing Economic Development zone, Zhejiang

Home | About Us | Products | News | Knowledge | Contact Us | Feedback | Mobile | XML

Copyright © Wenzhou Xihe Electric Co.,Ltd

share: